DFIC Error 74 - Missing File

Last reviewed: 12/15/2010
Article ID: R10619

The information in this article applies to:

• Tabs3 Billing Software Version 16, 15, 14 & 12
• Tabs3 Trust Accounting Software (TAS) Version 16, 15, 14 & 12

SUMMARY & RESOLUTION

This error can occur for one of two reasons:

• Tabs3/TAS has been configured, but no clients have been entered. Simply ignore the error 74 in this situation. Once clients are added, the error will be eliminated.
• A data file is missing or has been deleted. You must restore your Tabs3/TAS data files from a backup. It is important to note that if a file is missing, the Data File Integrity Check does not complete the entire search. Once this situation is resolved, make sure the Data File Integrity Check is run again to verify there are no errors. (Note:  If you are integrated with PracticeMaster, the Data File Integrity Check may report an error 500 and it may be necessary to restore your PracticeMaster data files. For more information, please refer to KB Article R10589, "DFIC Error 500 - PracticeMaster and Tabs3 / TAS Files Are Not Synchronized".)

References

• KB Article R10589 - DFIC Error 500 - PracticeMaster and Tabs3 / TAS Files Are Not Synchronized

THE INFORMATION PROVIDED IN THE SOFTWARE TECHNOLOGY, INC. KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. SOFTWARE TECHNOLOGY, INC. DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL SOFTWARE TECHNOLOGY, INC. OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF SOFTWARE TECHNOLOGY, INC. OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

© 1999-2012 Software Technology, Inc.   All rights reserved. Terms of Use
The maker of Tabs3 and PracticeMaster
Tabs3, PracticeMaster, and the “pinwheel” symbol () are registered trademarks of Software Technology, Inc.
e-Mail Suggestions for the Knowledge Base to: kb@Tabs3.com
Technical Support via e-mail is not available.
Knowledge Base:   http://support.Tabs3.com
Web Site:   http://www.Tabs3.com